Programming Magicspeed; Performing A Functional Test - Dometic MSBE 7 Instructions De Montage Et De Service

MagicSpeed MSBE7
7.2 Connecting the control lever
➤ Plug the connection cable of the control lever (fig. 7 1, page 5) as follows into the sockets of
the 8 pin plug housing (fig. 7 2, page 5):
– Blue into slot 1
– Brown into slot 2
– Yellow into slot 3
– Black into slot 4
– Slot 5 is not assigned
– Red into slot 6
– Green into slot 7
– Orange into slot 8
Make sure that the colours on the connection cables match those on the mating connector or
the colour markings on the plug housing.
➤ Lay the connection cable for the control lever to the electronic module.
➤ Plug the assembled 8-pin compact plug of the control lever into the 8-pin socket of the cable
set of the MagicSpeed cruise control (fig. 8, page 5).
8

Programming MagicSpeed

➤ Program MagicSpeed as described in the installation and operating manual of the cruise
control.
9

Performing a functional test

I
NOTE
The lowest speed at which the speed regulator can operate is approximately 30 km/h
and the highest approximately 140 km/h.
➤ Start the vehicle.
➤ Switch on the cruise control by pressing the control lever in the
✓ The LED on the control lever lights up green.
✓ You will hear two signals.
➤ Drive at a speed of approx. 40 to 50 km/h.
➤ Press the control lever in the
✓ The LED on the control lever lights up orange.
✓ The cruise control gently takes on the speed and maintains the driving speed constantly.
EN
direction to activate the cruise control.
Programming MagicSpeed
direction.
13