Table des Matières
Publicité
HULL
HOOD
HANDLEBAR
SERVICE POINTS
Handlebar inspection
1. Inspect:
Handlebar
Bends/cracks/damage → Replace.
Handlebar switch inspection
Refer to "STARTING SYSTEM" in
Chapter 7.
Handlebar assembly installation
1. Install:
Bands 1
NOTE:
After inserting the QSTS cables, buzzer
lead, handlebar switch lead and throttle
cable into the grommets, tie the end of
grommets with the bands.
2. Install:
Upper handlebar holder 1
NOTE:
Align the punch mark a on the handlebar
with the top surface of the handlebar
holder.
The upper handlebar holder should be
installed with the punch mark b facing
forward.
CAUTION:
Clearance c should be narrower than
clearance d.
Reference clearance:
c: 1.5 mm (0.06 in)
d: 3.5 mm (0.14 in)
8-6
E
Publicité
Chapitres
Table des Matières
