DeWalt DW735 Guide D'utilisation page 12

4. Repeat the procedure for the last dull knife.
After installing new knives:
1. Insert the round end of the dust shroud into the fan housing and
rotate it down to lock it into place.
2. Place the three wing nuts back into the shroud.
3. Screw the top cover of the planer back onto the unit.
NOTE: THE PLANER WILL NOT OPERATE IF THE TOP COVER
IS NOT PLACED CORRECTLY.
MAINTENANCE
Brush Change
Your planer is equipped with brush caps
(U) that are external to the motor. If your
brushes need to be replaced, begin by
acquiring a new set from a D
service center or a dealer authorized
to service D WALT products. Use only
E
identical D WALT brushes.
E
TO REPLACE THE BRUSHES ON
YOUR PLANER
TURN OFF THE PLANER AND UNPLUG
IT FROM THE POWER SOURCE.
1. Use the T-wrench to remove the top
cover and brush cover screen on the
planer.
2. Use a flathead screwdriver to unscrew
the brush cap located in the right, rear of the unit (V).
3. Do the same for the brush cap located on the side of the motor,
inside the planer cover.
4. Place the new brushes into the brush holders.
5. After installing the brushes, replace the top cover and brush
cover screen.
U
WALT
E
V
6. Before using the planer, run the unit for 10 minutes to seat new
brushes.
NOTE: If existing brushes do not need replacing, be sure to main-
tain the same orientation when you reinstall them.
Calibrating the Depth Adjustment Scale
The depth adjustment scale (N) on
your planer is set at the factory.
However, with extended use, the
depth adjustment scale could show
an incorrect measurement.
To check the depth adjustment scale,
plane a piece of scrap wood, noting
the measurement on the depth
adjustment scale.
Measure the finished thickness of the
workpiece. If the thickness of the
workpiece does not match the reading on the depth adjustment
scale, loosen the two screws (W) on the red indicator. Adjust the
pointer up or down until its reading matches the finished thickness
of the workpiece. Securely re-tighten the screws.
Base Maintenance
Keep the table clean and free from oil, grease, and pitch. Treat the
table with paste wax to help maintain its smooth finish.
Circuit Breaker Reset
Button
Your planer is equipped with an 18 amp
circuit breaker. If your planer becomes
overloaded and stops operating, turn off
the planer, let the unit sit for 2 minutes and
press the reset button (X) before you
resume working.
10
W
N
X