Intended Use; Misuse; Personnel Qualification; Specialist Personnel For Operation - HellermannTyton Autotool 2000 CPK Manuel D'utilisation

Safety warnings

2.2 Intended use

Use the device only when it is in full working order
and safe, always be safety-conscious and aware of the
hazards.
The AT2000 CPK is suitable for and intended for the
following uses:
• Automatic binding of bundles up to a diameter of
max. 20 mm
• For indoor use only
• Industrial use

2.3 Misuse

Use other than as stated in the section entitled "Intended
use" is misuse. The operator of the device bears sole
responsibility for injury and damage resulting from misuse.
The following are speciically prohibited:
• Use with faulty parts
• Use in explosive environments or in the presence of a ire
hazard
• Use outdoors
• Use in high humidity and/or direct sunlight
• Simultaneous use by two or more persons
• Unauthorised alterations and modiications to the device
and its component parts without the prior consent of
HellermannTyton
• Use of spare parts and accessories not tested and
approved beforehand by HellermannTyton
• Operation of the device without transparent covers itted
at the gate
2.4 Personnel qualification
Under-age persons and trainees are permitted to use the
device only under the supervision of an experienced
specialist and only with the express permission of the
operating company.

2.4.1 Specialist personnel for operation

The tasks and authorisations assigned to specialist
personnel for extended operation are as follows:
• Operation of the device
• Rectiication of faults or, as applicable, initiation of
measures for the rectiication of faults
• Cleaning of the device
These individuals have the specialist training or practical
experience that will ensure correct handling.
8
2.4.2 Specialist personnel for maintenance and
servicing
Always have maintenance and servicing carries out by
duly qualiied specialist personnel. These individuals have
the specialist training that affords suicient knowledge
of the device for them to judge when it is in safe working
order.
These individuals are also familiar with the following
rules and regulations:
• Applicable national health and safety regulations
• Accident prevention regulations
• Generally accepted rules of engineering practice
(e.g. employers' liability insurance association codes,
DIN standards, VDE regulations, technical rules of other
European Union member states or other states party
to the Agreement on the European Economic Area).
2.4.3 Authorised person for low-voltage electrical
equipment
Always have work on the electrical supply and on parts
that are live when the device is in operation carried out
by a person duly authorised to work on low-voltage
electrical equipment.

2.4.4 Authorised specialist for repair and testing

Only service technicians from HellermannTyton are
permitted to carry out repairs and safety checks.
2.5 Underlying hazards associated with use of the
device

2.5.1 Cleanliness at the workplace

Orderliness, good lighting and cleanliness at the work-
place all help to make work easier, minimise hazards and
reduce the risk of injury.
Always comply with the following principles of
orderliness and cleanliness at the workplace:
f Tidy tools away as soon as they are no longer needed.
f Avoid trips (e.g. immediately dispose of waste by placing
it in the containers provided for the purpose).
f Immediately remove spillages of grease, oil and other
liquids.
f Clean smears off the controls.

2.5.2 Spare parts and accessories

f It is advisable to use only OEM spare parts.
f After parts have been replaced, always make sure that
everything is in full working order.
f Use only accessories approved by HellermannTyton.
Accessories can affect the way in which the device
works.
AT2000 CPK• Operating Instructions • 04-2015 • 106-29004