Tank Cleaning; Malfunctions And Remedies - IARP EIS 104 TI Instructions D'emploi Et D'entretien

SEASONAL USE
When the unit is not used for a long time, please take note
of the following procedures:
- unplug the unit;
- clean and dry well the tank;
- leave the glass door open to avoid unpleasant smell;
- cover the unit and put it in a dry and sheltered place.

TANK CLEANING

By tank cleaning, proceed as follows:
1) Place the goods in special refrigerated containers, kept at the same temperature and remove the shelves
2) Unplug the unit
3) Leave the doors open and begin the operation of tank washing when the tank temperature is the
same as the ambient temperature.
4) Clean and dry the interior of the tank with a soft cloth, using neutral soap.
Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use jet of water to clean the cabinet: electrical wiring can have damages.
Never use mechanical devices or any other means to accelerate the defrosting process, other than
those recommended by the manufacturer.

MALFUNCTIONS AND REMEDIES

Most of the functioning inconveniences are generally due to defective electrical connections.
These problems can usually be solved on the place.
The unit does not start:
-check that there is voltage at the wall socket;
-check that the unit is properly plugged.
The internal temperature is not cold enough:
-check that the unit is not placed too close to any heating source;
-check that the condenser is not blocked by dirt;
-check that behind the cabinet air can properly circulate;
-check the perfect closing of the sliding glass door;
The unit is noisy:
-check that all the bolts and nuts are properly fasten;
-check that the unit is placed on an even surface;
-check if any pipe or fan is in contact with any other part of the body.
DISPOSAL
The cabinet contains oil, plastic and metallic components and glass .
Warning!
Polyurethane insulation uses CICLOPENTHANE as expander, that doesn't affect the environment
but is inflammable.
To guarantee the same respect when it's disposed of , never abandon the equipment outside.
Don't throw the packaging material from your equipment in the rubbish but sort the various materials:
eg.polystyrene, cardboard, plastic bags.
The demolition of the cabinet and the recovery of the component materials must be carried out according
to the local regulations in force in this matter.
INFORMATIONS ABOUT SERVICE
-11-