Storing The Tool; Instructions For Periodic Maintenance - Makita UA002G Manuel D'instruction

Storing the tool

1. Clean the tool before storing. Remove any chips
and sawdust from the tool after removing the sprocket
cover.
2.
After cleaning the tool, run it under no load to lubri-
cate the saw chain and guide bar.
3. Cover the guide bar with the guide bar cover, and
then shorten the pipe.
4. Empty the oil tank.

Instructions for periodic maintenance

To ensure long life, prevent damage and ensure the full functioning of the safety features, the following maintenance
must be performed regularly. Warranty claims can be recognized only if this work is performed regularly and properly.
Failure to perform the prescribed maintenance work can lead to accidents! The user of the tool must not perform
maintenance work which is not described in the instruction manual. All such work must be carried out by our autho-
rized service center.
Check item / Operating time
Entire tool Inspection.
Cleaning.
Check at
authorized
service center.
Saw chain Inspection.
Sharpening if
necessary.
Guide bar Inspection.
Remove from
the tool.
Chain Check the oil
lubrication feed rate.
Switch trigger Inspection.
Lock-off lever Inspection.
Oil tank cap Check
tightness.
Screws and Inspection.
nuts
Before Everyday
operation
-
-
- -
-
- -
- -
-
-
-
-
- -
21 ENGLISH
Every week Every 3
month
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
-
Annually Before
storage
- -
- -
- -
-
- -
-
- -
- -
- -
- -
- -