Connections - Denon D-A03 Mode D'emploi

ENGLISH

CONNECTIONS

2
• Do not plug in the power plug into an outlet until all connections
have been completed.
• Insert the power plug securely. An incomplete connection will
cause noise to occur.
(1) Connecting Antennas and Audio Equipment
Assembly of the AM loop antenna
1. Pull out
Rear Panel Names and Connections
q
FM antenna terminal
w
MONO output terminal
e
AUX input terminal
r
AM loop antenna terminals
• These connect the supplied AM loop antenna.
Connection of Audio Equipment
Super woofer
50
MIN
FM antenna
6
2. Bend 3. Insert into hole
NOTES:
• Do not bundle the (pin plug) connection cables together or place
them close to other electrical products such as TVs since this may
cause hum or other noise.
Connection of the AM loop antenna
1. Lower the lever
q
MONO
OUT
ANTENNA
To listen to equipment that is connected to the external input
terminals, set the input to "AUX" with the remote control
external input selection button.
Power cord
Use a connection cable
that is available on the
market.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC which provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
2. Insert wire 3. Release
w e r
AUX IN
AM
FM
LOOP ANT.
Portable player, etc.
AM loop antenna