Use And Operation - WMF LINEO Mode D'emploi

Use and operation

1. Fill the jug (4) with the required quantity of milk and then close the lid (1).
2. Now place the jug (4) on the base unit (6).
Caution:
Always put the lid (1) on the gadget first before switching it on.
Never remove the lid (1) while the gadget is switched on.
Otherwise, the WMF milk froth DISC (3) may no longer function correctly even
when the lid (1) is replaced.
Note:
preparation can be stopped at any time by pressing the start/stop button (5) or by
removing the jug (4) from the base unit (6).
Allow the appliance to cool down before using again.
The texture and volume of the milk froth depend on the type of milk used
(including fat content, protein content, temperature).
Soft creamy milk froth
Select this program for warm, creamy, fine-pored milk froth. This is particularly
suitable for cappuccino or latte style coffee.
▪ Fill the jug (4) with 100 to 150ml of cold milk.
The jug (4) is marked with the following measures:
100 ml MIN
150 ml MAX
DO NOT overfill the jug, otherwise the milk froth will overflow and spill over
the appliance.
▪ Place the lid (1) on the jug (4) and push down gently to seal.
▪ Now press the start/stop button (5) repeatedly until the lamp for the
symbol illuminates. After approximately 3 seconds, the appliance starts
automatically, the control lamp for the start/stop button (5) is illuminated.
▪ After the program has finished, the appliance automatically switches itself off,
the control lamp is no longer illuminated. Lift the lid (1) and skim off the milk
froth separately or pour it out with the rest of the milk.
Firm milk froth
Select this program if you require a warm, firmer consistency of milk froth. This is
particularly suitable for cappuccino or latte macchiato style coffee.
▪ Fill the jug (4) with 100 to 150ml of cold milk.
The jug (4) is marked with the following measures:
100 ml MIN
150 ml MAX
DO NOT overfill the jug, otherwise the milk froth will overflow and spill over
the appliance.
▪ Place the lid (1) on the jug (4) and push down gently to seal.
▪ Now press the start/stop button (5) repeatedly until the lamp for the
symbol illuminates. After approximately 3 seconds, the appliance starts
automatically, the control lamp for the start/stop button (5) is illuminated.
▪ After the program has finished, the appliance automatically switches itself off,
the control lamp is no longer illuminated. Lift the lid (1) and skim off the milk
froth separately or pour it out with the rest of the milk.
15