Avdel 74101 Manuel D'instructions page 44

Maintenance
TO RESET CLUTCH TORQUE
•
Ensure the correct coloured/wire diameter Clutch Spring is selected in order to obtain the required torque.
•
With a minimum gap set between Adjusting Ring 15 and Circlip 14 and using the Clutch Key (74101-12301), rotate 15 (anti clockwise)
until the required number of full turns have been completed to obtain the required Torque as shown in the Table below.
•
White numbers on black background indicate Number of turns. Black numbers on white background indicate expected Torque in 1bf ins.
• Immediately after setting clutch check for correct operation and insert installation (number of turns offer a
setting guide only).
•
At torque settings above 4 Nm (35lbf/in
CIRCLIP 14
SPRING TORQUE lbf.in (Nm) SPRING COLOUR /
SPRING No.
74101-***** Min Max
Spring 12352 5.3 (0.6) 24.7 (2.8)
Spring 12351 17.7 (2.0) 48.6 (5.5)
Spring 12353 22.1 (2.5) 66.3 (7.5)
2 ) side handles on the tool are recommended. (Refer to Safety Rules page 4)
CLUTCH SPRING
ADJUSTING RING 15
74101 CLUTCH DETAILS
WIRE DIA. 1
Blue / 2.80mm
4.4 5.8
Natural / 3.33mm
Natural / 3.45mm
Nº OF TURNS/lb f ins
2 3 4 5 6 7
7.1 8.9 10.6 12.4 14.2 15.9 17.7 19.5 21.2
18 22 27 31 35
22.1 29.2 36.3 43.4 50.4 57.5 66.4
8 9 10 11 12 13
23.0 24.8
40 44 49
17