Omron SpotArm i-Q132 Mode D'emploi page 18

HEM-1010-E_[D].book 18 ページ ２０１１年１１月１５日 火曜日 午後７時３５分
2. Preparation
Adjusting the Date and Time Setting
Note: If you need to change the date and time for some
reason, or if the date and time has been reset after
replacing the batteries, adjust the date and time between
10:00 and 18:59. This will avoid problems with morning
and evening weekly averages stored in the memory.
1.
Press the O/I button to turn the power off.
2.
Turn the unit on then press
and hold the MEMORY button
for three seconds or longer
when the standby display
(shown right) appears.
3.
The year setting flashes on
the display.
Refer to Chapter 2.3 to adjust
the settings for the date and
time.
18
Standby display
(When the arm cuff is closed.)