Free Room; Installation - Daikin LMD MF075 Manuel D'installation

6.4 Free room

When installing the unit leave enough free room to allow opening, correct use and easy maintenance in safe
conditions.

6.5 Installation

Prepare an opening with suitable dimensions in the cold room wall (see picture).
A
Condensate drain
line D (I)
LMD MF075/LF170
LMD MF100-120/LF200
LMD MF230/LF350
LMD MF350/LF500
LMD MF400-600/LF600-750
LMD MF750/LFM000
A) Position the unit on the cold room inserting the evaporator section in the opening.
B) Fix the unit using the screws supplied.
C) Fit a drain line to the defrost water drain connection in the lower part of the condensing
unit.
N.B.: Before siting the unit (only for the models LMD MF075/LF170), dismount the front panel
-Iniettare silicone su tutto il perimetro del tampone.
Sul lato superiore eseguire l'operazione prima del posizionamento.
-Inject silicone all around the panel opening.
Apply silicone on the upper side before positioning the unit.
-Injecter de la silicone sur tout le périmètre du tampon.
Sur la partie supérieure injecter avant de fixer l'Uniblock.
-Silikon auf den ganzen Öffnungsumfang einspritzen.
Bevor der Uniblock eingebaut wird, dieses Verfahren auf der Oberseite ausführen.
-Inyectar silicona sobre todo el perimetro del agujero.
Sobre la parte superior se coloca antes de situar el Uniblock.
Inject silicone seal all around
the panel opening
A B C
705 300 305
695 300 305
800 470 400
857 470 440
857 500 440
857 570 490
-Foro
-Hole
-Trou
-Loch
-Agujero
425
Hole
D E F
100 420 305
100 420 305
120 580 475
120 580 480
120 850 510
120 970 580
G H I
425 100 10
725 100 10
725 100 10
1130 100 18
1600 100 22
1640 100 22
A.
21