Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Then attach the solar cell as shown in Fig. C.
Next adjust the solar cell to face south.
Connecting the solar cell to the main unit
After mounting the two operating units (main unit
the cable so it is not subjected to mechanical stress. Use typical installation
material such as cable clamps or conduit to fasten the cable, to prevent
damage to the insulation.
Connect the plug connector
cell (see Fig. D).
Start-up
Note:
Connect the main station
first time. The solar cell
motion sensor
When selecting the setup location for the solar cell
solar cell, just as the twilight sensor, are not affected by other light
sources, e.g. street lighting.
The switch
on the main unit
5
Position „OFF":
Position „AUTO":
from the main unit cable and the solar
4
to the solar cell
1
also works as a twilight sensor, while the
6
only responds to movement.
3
(Fig. A) features the following functions:
1
Sensor
and spotlight
3
the rechargeable batteries are charged by the solar
cell
. Use this setting to charge drained batteries
6
(see „Charging the rechargeable batteries").
The spotlight automatically switches on or off once
the solar cell
6
long life the LEDs will not be fully powered in this set-
ting, but only provide approx. 25 % of their full light
and solar cell
1
before using for the
6
are off. In direct sunlight
2
detects dusk or dawn. To ensure a
) run
6
be sure the
6
GB/IE
11
Publicité
Chapitres
Table des Matières
