Replacing The Batteries; Storage, Cleaning - LIVARNO LUX LG-9483 Notice D'utilisation

• Check the product for damage or wear
before each use. Only use the product if it is in
perfect condition!
• No modifications may be made to the prod-
uct!
• The product's light source is not replaceable;
the entire light must be replaced once the light
source has reached the end of its service life.
Warnings on batteries!
• Remove the batteries if they are empty or if
the product is not going to be used for an
extended period.
• Do not use different battery types or brands,
new and used batteries in combination, or
batteries with different capacities, as they leak
and can thus cause damage.
• Observe the polarity (+/-) when inserting
batteries.
• Change all batteries at the same time and
dispose of the old batteries properly.
• Warning! Batteries may not be charged or
reactivated in any way. They may not be
dismantled, thrown into fire, or short-circuited.
• Always keep batteries out of the reach of children.
• Do not use rechargeable batteries!
• The cleaning and user-maintenance may not
be carried out by children without supervision.
• Clean the batteries and the device contacts as
necessary and before inserting the batteries.
• Do not expose the batteries to extreme
conditions (e.g. radiators or direct sunlight).
Otherwise there is an increased risk of leaks.
• Batteries can endanger life if swallowed. Keep
batteries out of the reach of small children for
this reason. Seek medical help immediately if
a battery is swallowed.
Danger!
• Handle a damaged or leaking battery with
extreme care and dispose of it properly and im-
mediately. Wear gloves to handle the battery.
• If you come into contact with battery acid then
wash the affected area with soap and water.
If battery acid gets in your eye rinse it out with
water and seek medical help immediately!
• Do not short-circuit the terminals.
8 GB/IE
Inserting the batteries (Fig. A)
WARNING! Observe the following
instructions to avoid mechanical and
electrical damage.
The products (1) come with three batteries,
which must be taken out of their packaging
before you insert them.
1. Remove the battery compartment cover (1a)
from the battery compartment (1b).
2. Place the batteries (2) in the battery holder.
Note: check the plus/minus poles of the batter-
ies and insert them correctly.
The batteries must be completely inside the
battery holder.
3. Close the battery compartment cover (1a)
again.

Replacing the batteries

When the batteries are flat, you can replace
them.
Follow the instructions in the section 'Inserting the
batteries'. Before inserting new batteries, remove
the old batteries from the battery compartment.
Turning the light on and off
(Fig. A)
Slide the switch (1c) to 'ON' to turn the prod-
uct (1) on. Slide the switch (1c) to 'OFF' to turn
the product off. Slide the switch (1c) to 'TIMER'
to activate the product's timer function.
Note: using the timer function, the light will be
on for 6 hours and off for 18 hours.
Use
The product can be placed indoors.
Note: do not place the product on delicate
surfaces. This can lead to scratches.

Storage, cleaning

When not in use, always store the product dry,
clean, without batteries and at room tempera-
ture.
Only clean the product with a damp cloth and
wipe dry afterwards.
IMPORTANT! Never clean the product with
harsh cleaning agents.