Start-Up; Switching The Pro Duct On / Off Using The Remote Control - LIVARNO LUX HG00146 Instructions D'utilisation Et Consignes De Sécurité

LIFE BY ELECTRIC SHOCK!
Before performing any work, first
disconnect the product from the
mains power. Unplug the power
supply from the socket.
3
Connect as described below:
Remove the protective film
from the double-sided adhe-
sive strip at the ends of the LED
strip sections being connected.
Then firmly press the end of
the one LED strip onto the pins
on the connector
pierce the strip conductor of
the LED strip.
Note: Be sure to match up the
VGGD mark on the connector
with the VCC-GND-GND-D0
and VCC-GND-GND-DI mark
on the LED strip.
Then push a plastic clip
onto this new connection
from the top.
Note: Be sure the plastic
clips lock in to establish a
secure connection.
DANGER TO
so they
1
11
Repeat this process to estab-
lish a contact for the other end
of the connector.
Note: Unlike the LED strip,
the connector can be moved
in any direction:
has delicate solder points.
Do not route the LED strip
around corners and do not
kink. The solder points may
otherwise be damaged, dis-
rupting the functionality of
the LED strip.

Start-up

Switching the pro-
duct on / off using
the remote control
Note: The infrared receiver
located on the LED controller
Always aim the remote control
directly at the infrared receiver for
best reception. The range of the
remote control is approx. 6–8 m.
Note: Remove the insulating strip
from the battery compartment
The product
is
6
.
4
7
GB/IE/NI 13