DigiSender DGXDSDV112 Mode D'emploi page 9

DGXDSDV112 - DigiSender® XDHDMI - Single Input HDMI AV Sender System
continued...
5.
The DigiSender® XDHDMI Boot Screen will be dis-
played whilst the Receiver locks on to the Transmit-
ters signal.
7.
You will notice that at the top right corner of the
screen is a blue Test Bar with some information on
it. If the Test Bar is not present, then your Receiver
may not be in Test Mode. Flick the Mode Switch on
the back from Normal to Test and turn the receiver
off and then back on again.
Please read the instructions carefully prior to installation
6.
After approximately 5 seconds the picture will
change to whatever you are transmitting. If the pic-
ture does not change, or changes to the DigiSender®
Test Card, you may need to re-sync the Transmitter
and Receiver. See page 12 for more details.
8.
The first number indicates the Frame Rate that the
Receiver is picking up from the Transmitter and out-
putting to your TV.
ENGLISH (EN)
Page 09