Netatmo NDB-PRO Guide De L'utilisateur page 47

Masquer les pouces Voir aussi pour NDB-PRO:
Table des Matières

Publicité

FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation.
lf this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encou-
raged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device NDB01 complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for general
population (uncontrolled exposure). This device must be installed to provide a
separation distance of at least 20cm from all persons and must not be collocated
or operating in conjunction with any other antenna or transmitter.
Caution
This equipment may not be modified, altered, or changed in any way without
signed written permission from NETATMO. Unauthorized modification may void
the equipment authorization from the FCC and will void the NETATMO warranty.
Canadian Compliance Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Ope-
ration is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interfe-
rence that may cause undesired operation of the device. Under Industry Canada
regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful communication. This device complies
with Industry Canada RF radiation exposure limits set forth for general population
(uncontrolled exposure). This device must be installed to provide a separation
distance of at least 20cm from all persons and must not be collocated or opera-
ting in conjunction with any other antenna or transmitter. Le présent appareil est
conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) il ne doit
pas produire de brouillage, et (2) l'utilisateur du dispositif doit être prêt a accepter
tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de
compromettre le fonctionnement du dispositif. Le présent appareil est conforme
aux niveaux limites d'exigences d'exposition RF aux personnes définies par In-
dustrie Canada. Cet appareil doit être installé afin d'offrir une distance de sépara-
tion d'au moins 20cm avec l'utilisateur, et ne doit pas être installé à proximité ou
être utilisé en conjonction avec une autre antenne ou un autre émetteur.
92
Taiwan Wireless Statements
無線設備的警告聲明
本產品符合低功率電波輻射性電機管理辦法 第十二條、十四條等條文規定:
1.經型式認證合格之低功率射頻電機,非經許可,公司、商號 或使用者均不得
擅自變更頻率、加大功率或變更原設計之特性及功能。
2.低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干 擾現
象時,應立即停用,並改善至無干擾時方得繼續使用。 前項合法通信,指依電
信法規定作業之無線電通信。 低功率射頻電機須忍受合法通信或工業、科學
醫療用電波輻射性電機設 備之干擾。
Wireless connectivity / Connexion sans-fil / Drahtlose Konnektivität / Conexión
inalámbrica / Connessione senza fili / Draadloze connectiviteit / Trådlös
anslutning / Trådløs tilkobling / Беспроводная связь / 无线连接 / 無線連接 / ワ
イヤレス接続
Wi-Fi and Bluetooth: 2400-2483,5 MHz @ 80 mW
Legal Notice
Use of the Works with Apple HomeKit badge means that an electronic accessory
has been designed to connect specifically to iPod touch, iPhone, or iPad, respec-
tively, and has been certified by the developer to meet Apple performance stan-
dards. Apple is not responsible for the operation of this device or its compliance
with safety and regulatory standards.
Controlling this HomeKit-enabled accessory automatically and away from home
requires an Apple TV with tvOS 10.x or later or an iPad with iOS 10.x or later set
up as a home hub.
Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S.
and other countries. App Store is a service mark of Apple Inc.
Android, Google, Google Play and related marks and logo are trademarks of
Google LLC.
CE marking is the manufacturer's declaration that the product meets
the requirements of the applicable EC directives.
The product meets the safety requirements specified for Class II
equipment according to IEC 61140.
The product complies with the requirements of the relevant ACMA
Standards.
WEEE symbol designates safe and responsible collection, recycling
and recovery procedures for all types of electronic waste.
The product complies with the Technical Regulations Conformity Cer-
tification of Specified Radio Equipment.
M/N:
Model Number
The product complies with the limits for a Class B digital device,
FCC ID:
pursuant to part 15 of the FCC rules (USA).
The product complies with Industry Canada license-exempt RSS
IC:
standard(s).
gXXXXXX
Serial number
8-24V
The product requires an AC power supply to operate properly.
50/60Hz
It accepts voltage from 8 to 24V or from 220 to 240V, with a frequency
300mA
of 50Hz or 60Hz.
220-240V
50/60Hz
32mA
Installation and safety instructions must be read carefully before use.
Caution is necessary when operating the device.
93

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ndb01

Table des Matières