Before Initiation; Transport, Location And Set-Up Of The Water Still - conatex GFL Water Stills 2002 Notice D'utilisation

3. Before Initiation

Important information are marked in bold letters in these instructions,
safety indications are additionally marked by the following warning
symbols and mandatory signs.
Warning of hot
liquids and
vapour
Warning of
dangerous
electrical
voltage
All free openings of the water connections on the right-hand side of the unit are taped. These
transport protections. These protections have to be removed before initiation.

4. Transport, Location and Set-up of the Water Still

Protect yourself and the unit during transport and setup by working carefully
and avoid danger of e.g. shifting or tilting the unit as well as risk of injury by
lifting heavy loads.
Caution, Water Stills 2004 (net weight 21.8 kg), 2008 (net weight 35.8 kg) and
2012 (net weight 40.9 kg) must be lifted, carried and transported to the location
by at least two persons.
The Water Still can be held between the four stands of the unit and lifted
for setup.
The unit is suitable for both bench and wall mounting. It is only suitable for indoor use.
Table-top setting-up on solid, even and level surfaces only. Make sure to place the unit only
on a watertight, temperature-resistant, non-flammable surface. The location must provide
sufficient space as well as the necessary carrying capacity for the total weight of the unit (unit
weight as per technical data, chapter 11 of this manual, plus weight of the filling).
For setting-up on the wall check the carrying capacity of the wall in connection with the total
weight of the unit (appliance plus water filling, see Technical Data). Make sure to check the on-
site fixing elements in order to guarantee safe hold of the Distiller. The fixing material must be
suitable for the substrate. Use only tested and proven fixing material.
There are two keyholes for wall mounting at the back of the Water Still. Place two fixing screws
(not included in the scope of supply) in the wall in the distance of the two keyholes and nest the
still on the keyholes. The unit is delivered without fixing material.
The unit is not suitable for use in potentially explosive surroundings, e.g. during anaesthesia
with inflammable gas or steam types!
© Tous droits réservés –
Warning of
hot surfaces
General
warning
Model / Distance of screws
2002 / 40 cm 2004 / 48 cm
2008 / 64 cm 2012 / 64 cm
France : web: www.conatex.fr – Email: info@conatex.fr
Suisse : web : www.conatex.com – Email : info@conatex.com
Notice d'utilisation
Distillateur 116.3050
Read and observe the
operating instructions
Before maintenance and repair
disconnect the unit all-pole
from the electrical mains (pull
the plug from the socket).
13