Care And Maintenance; Cleaning And Daily Disinfecting; Cleaning - Omron Comp Air NE-C28-E Mode D'emploi

NE-C28.book Page 17 Monday, October 23, 2006 3:40 PM

Care and maintenance

5. Cleaning and daily disinfecting

5.1

Cleaning

Following the cleaning instructions after each use will prevent any remaining
medication in the tank from drying, resulting in the device not nebulising effectively
and also for preventing infections.
Warning:
Thoroughly rinse the nebuliser and the mask, nosepiece or mouthpiece with
clean hot tap water after each use, and disinfect the parts of the nebuliser kit
and applicable inhalation attachments after the last treatment of the day.
Note: Do not start operation before the cleaned parts are completely dried.
1.
Make sure that the power switch is in the
2.
Unplug the power cord from the electrical outlet.
3.
Remove the nebuliser kit from the air tube and disassemble the nebuliser
kit. (see Section 3)
4.
Discard any remaining medication in the
medication tank.
5.
Wash all the nebulising parts in warm water and mild detergent and rinse in
clean hot tap water, or wash in a dishwasher.
For instructions on how to disinfect the parts, see the following section.
6.
After cleaning and disinfecting the parts, rinse them thoroughly with clean
water and allow the parts to air dry in a clean environment.
(off) position.
EN
17