Food Compartment; Freezer Compartment; Operation; Controls - Norcold DCL4 Série Manuel D'utilisation Et D'installation

Food compartment:

Start up the refrigerator and let it cool for eight hours before loading with food. If the refrigerator does not start to cool down after about
two hours, contact your dealer or an authorized Norcold Service Center.
For the best cooling performance:
- Let air move freely inside the entire food compartment.
- Do not cover the shelves with plastic, paper, etc.
To decrease the amount of ice that collects on the freezer plates:
- Cover all liquids and moist foods.
- Let all hot foods cool before putting them in the refrigerator.
- Do not open the door any longer than necessary.

Freezer compartment:

The freezer compartment is made to keep pre-frozen food frozen and not to quick freeze food. Keep pre-frozen foods in the freezer
compartment.
When making ice, put the ice cube tray directly on the freezer surface. Do not put other items on the ice cube tray while
NOTICE
the water is freezing.

Operation

Controls:

This refrigerator is made for refrigerating purposes and operates on a 12/24 volt DC power supply when installed as written in this
manual.
On DCL4XXX models, the controls are located in the right-hand upper rear corner of the food compartment of the refrigerator.
On DCL5XXX models, the controls are located inside the freezer door on the right-hand side of the freezer compartment.
The refrigerator temperature is controlled by a thermostat [1] (See Art02246). Number "0"
is the "OFF" position. The thermostat will firmly "click" in and out of the "0 - OFF" position.
Number "1" is the warmest and number "5" is the coldest thermostat position. For efficient
operation, change the thermostat according to the types of food stored and the ambient
temperature.
Do not operate the refrigerator when the ambient temperature is higher
NOTICE
than 110° F.
Cooling unit protection systems:
The BD compressor system protects against conditions that can result from high ambient
temperatures or short on/off cycling of the unit. These conditions are compressor
overload and start failure, fan overload, electronic unit overheating, or destructive battery
discharge.
If the overload or start failure protection activates, the compressor will stop. The
compressor will automatically attempt to restart, about once per minute, until it successfully restarts.
If the temperature of the electronic unit is too high, the compressor will stop. The compressor will restart automatically when the
temperature of the electronic unit lowers.
If the compressor stops due to overload or electronic unit overheating, the fan will continue to run.
If the fan current is more than 0.5 amps, the fan over load protection stops the compressor and the fan.
Installation and Owner's Manual 6
OFF
ARRÊT
0
5
1
4
3
1
2