Cleaning The Spray Arms; External Cleaning; Troubleshooting - Electrolux ESI6515LAK Notice D'utilisation

32 www.electrolux.com

9.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.

9.3 External cleaning

Clean the appliance with a moist soft
cloth.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with
water.
Problem
You cannot activate the appli-
ance.
The programme does not start.
2. To disassemble the filter (A), pull
apart (A1) and (A2).
3. Remove the filter (B).
A1
4. Wash the filters with water.
5.
Before you put the filter (B) back,
make sure that there are no residues
of food or soil in or around the edge
A2
of the sump.
6. Make sure that the filter (B) is cor-
rectly positioned under the 2 guides
(C).
7.
Assemble the filter (A) and put it back
in filter (B). Turn it clockwise until it
locks.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
•
water.
•
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse in
the fuse box.
Make sure that the appliance door is closed.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
- The appliance does not drain the
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.