Troubleshooting Support - DURAVIT Air-System Notice D'utilisation

> Allow the water in the tub to settle for 5 minutes.
> Turn on the air nozzles again for 20 seconds.
> Drain the water and rinse the tub.
> Fill the tub with water again.
> Turn on the air nozzles for 20 seconds.
> Drain the water.
> Wait until the tub has emptied completely.
> The air cleaning process starts after about 2 minutes.
> Wait until the air cleaning process is finished (about 4 mins.).
> Switch off the main switch.
> Repeat the process as necessary.
6. Troubleshooting Support
CAUTION
The whirltub may be repaired only by a qualified plumber and electrician.
Problem
Foaming
Whirltub system does not
start?
Motor-related noise after
emptying the tub
Sound volume / quality can-
not be changed.
22
Potential cause
Soap or shampoo in the
bathwater.
Mains switch is switched off.
Mains fuse is switched off.
Ground-fault switch (RCD) or
circuit breaker has tripped.
Any remaining water has
drained from the pipes.
Data not compatible.
Solution
Switch off the whirltub system.
Fill the tub with fresh water.
Switch on at the mains.
Switch on the mains circuit
breaker.
Disconnect the tub from the
mains.
Call customer service.
Check whether the audio source
supports the A2DP protocol.