Philips ClearTouch GC536 Mode D'emploi page 25

EN
Problem Possible cause
The appliance The steamer has not
produces no steam heated up sufficiently.
or irregular steam.
Steam has condensed in
the hose.
The water level is below
the MIN level indication
or the tank is not
inserted properly.
Too much scale has built
up in the appliance.
Water droplets drip You have left the
from the steamer steamer head and/or
head or the appliance the steam supply hose in
produces a croaking horizontal position for a
sound. long time.
When the hose forms a
U-shape, condensation
in the hose cannot flow
back into the water tank.
An excessive amount The water in the
of water drips out appliance is dirty or
of the steamer head has been left inside the
when the appliance is appliance for a long time.
heating up.
Water leaks out from You have not closed the
the steamer base. water tank cap or easy
rinse knob securely.
The water tank is not
inserted properly.
A few water droplets This is part of the water
come out when inlet design.
the water tank is
detached.
Solution
Let the appliance heat up for
approximately 45 seconds. Use
for faster heat up (GC536 only).
Lift the steamer head to straighten
the hose vertically. This allows any
condensation to flow back.
Refill the water tank and insert it
properly until you hear a "click"
sound.
Perform easy rinse process. Refer
to section.
Lift the steamer head to straighten
the hose vertically. This allows any
condensation to flow back.
Lift the steamer head to straighten
the hose vertically. This allows any
condensation to flow back.
Perform easy rinse process. Refer
to section.
Close the water tank cap and easy
rinse knob securely.
Insert the tank properly until you
hear a "click" sound.
This is normal.
25