Dometic PERFECTWALL PW3800 Notice D'utilisation page 17

PW3800
7.5 Setting up the struts
Putting up the struts
➤ Push the right strut in the front cover together so that you can move it freely
(fig. 5, page 5).
➤ Turn the right strut to the side (fig. 5, page 5).
➤ Fold the right strut down and set it on the ground (fig. 6, page 5).
➤ Adjust the strut to the required height (fig. 7, page 6).
➤ Fold the lever for the strut up to secure the struts (fig. 8, page 6).
➤ Extend the other strut in the same way.
Positioning the struts on the ground
!
WARNING! Beware of injury
• Only position the struts on solid ground.
• Secure the struts from slipping.
➤ Position the struts vertically underneath the lead rail.
➤ Secure the struts with pegs (fig. 9, page 6).
➤ Position one of the struts slightly lower so that the lead rail hangs at an angle. This
allows rain to run off more easily (fig. 0, page 7).
Securing the struts on the vehicle
You can secure the awning on your vehicle directly if you have already mounted the
latches for the struts.
➤ Slide the cover of the latch up (fig. a, page 7).
➤ Fit the struts into the latch (fig. a, page 7).
➤ Slide the cover of the latch down (fig. a, page 7).
➤ Position one of the struts slightly lower so that the lead rail hangs at an angle. This
allows rain to run off more easily (fig. b, page 7).
Putting in the struts
➤ Loosen the struts from the fastenings (pegs or latches on the vehicle).
➤ Fold the lever of the right strut down to loosen the struts.
EN
Operating the awning
17