Maintenance And Care - Windsor Radius Mini Mode D'emploi

Insert the battery
see Figure 4
Insert the battery into the intake and
lock it.
Operation
Lock/unlock telescope strut on the
see Figure 5
The Cardan joint can be locked to clean
high-fiber carpets to prevent the telescope
strut from moving from side to side.
– Lock/unlock telescope strut on the side:
Activate the lock, then move it down
and lock it in.
– Unlock telescopic strut:
Activate the lock, then move it up and
lock it in.
Starting the work
see Figure 6
Switch on the appliance; press the on/
off foot switch to do so.
Move the appliance forward and back-
ward to clean it.
Use the right side (battery side) to clean
the appliance close to the edges.
Interrupting the work
see Figure 7
Switch off the appliance; press the on/
off foot switch to do so.
To ensure that the telescopic strut
stands safely during breaks in opera-
tion, hold it vertically; there is a stopper
that holds it in position.
Finishing your work
Switch off the appliance when finished.
Empty dirt container after each clean-
ing.
Press the unlocking button of the bat-
tery and remove the battery.
Charge the battery.
6
English
side
Emptying the dirt container
see Figure 8
Unlock the dirt container and remove it.
Empty the dirt container.
Insert and lock into place the dirt con-
tainer.
Storing the appliance
The appliance can be hung with the
handle; turn the handle if required (see
chapter "Install Telescopic strut and
handle and adjust the height").

Maintenance and care

Caution
Remove the battery prior to any care and
maintenance work.
Cleaning the device
Wipe the appliance using a damp cloth.
Do not use any aggressive agents,
such as cleaning powder.
Change/ clean the brush roller
see Figure 9
Press the unlocking button and remove
the brush roller.
Remove wound up hair using a knife or
scissors by moving the knife along the
defined cutting edge of the brush roller.
Remove loosened hair from the brush
roller.
Insert the cleaned or new brush roller
and ensure that it sits properly.
Service
Troubleshooting
Charger display does not glow
Check connection from charger to bat-
tery
Check power supply of the socket.
Appliance does not clean properly
Clean or replace the brush rollers (refer
chapter "Replace/ clean brush roller").