Windsor Radius Mini Mode D'emploi page 5

– Use the charger only to charge ap-
proved battery packs.
– Insert only clean and dry battery packs
on the adapter of the charger.
– Do not charge batteries (primary cells);
risk of explosion.
– Do not charged damaged battery
packs. Replace damaged battery
packs.
– Do not store battery pakcs along with
metal objects; risk of short circut.
– Do not dispose off battery packs by
throwing them into fire or into house-
hold garbage.
– Avoid contact with liquids oozing out of
defective battery packs. Rinse thor-
oughly if you accidentally come in con-
tact with the fluid. Also consult a doctor
if the fluid comes in contact with your
eyes.
Symbols on the machine
– Protect the charger against moisture;
store it dry. The appliance is suitable
for use only in rooms; do not expose the
appliance to rain.
Start up
Description of the Appliance
When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
Note: Please refer to page 2 for figures of
the appliance and the operation.
1 Cardan joint with lock
2 ON/OFF foot switch
3 Rechargeable battery, detachable
4 Unlocking button, battery
5 Dirt container, detachable
6 Unlocking mechanism for dirt container
7 Casing
8 Brush roller, changeable
9 Unlocking button for brush roller
10 Telescopic strut, adjustable height
11 Turning handle for height adjustment
12 Handle
13 Charger with charging status display
and charging cable
Installing the telescopic handle and
the handle and adjusting the height
see Figure 2
The telescopic strut consists of 3 parts.
While assembling it, make sure that the
parts lock into each other.
Insert the handle on the longer strut
with turning handle.
Insert together the longer and shorter
struts; while assembling it, press the
locking button.
Insert the entire strut with the locking
button into the joint on the appliance.
Loosen the handle and pull out the strut
to the desired working height; turn the
handle to the correct position and tight-
en using the turning handle.
Charge the battery
see Figure 3
The battery is not charged at the time of de-
livery. Charge it before commissioning the
appliance and then as and when required.
Note
The battery can be charged only when it is
removed out of the appliance.
Connect battery with charger using the
charger cable.
Insert the charger delivered with the ap-
pliance into a proper socket.
The charger display glows red. The battery
is being charged.
Note
– The charging time for an empty battery
is approx. 12 hours.
– If the charging time is exceeded, the
charger shifts to retention charging.
The charger display continues to glow
red.
5
English