EQUATION IFH04-33A-N Notice De Montage, D'utilisation Et D'entretien page 49

Table des Matières

Les langues disponibles

If the supply cord is damaged, it must be replaced by the manufacturer, its service

●

agent or similarly quali ed persons in order to avoid a hazard.

CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal

●

cutout, this appliance must not be supplied through an external switching device, such as

a timer, or connected to a circuit that is regularly switched on and o by the utility.

WARNING: In order to avoid overheating, do not cover the heater.

●

The heater must not be located immediately below a socket-outlet.

●

Do not use this heater in the immediate surroundings of a bath, a shower or a

●

swimming pool.

CAUTION: This mobile heater is intended to be used mainly in workshops, craftsmen or

garages. Do not use in bathrooms.

3. INSTALLATION

WARNING:This portable heater is intended mainly to be used in workshops, light

industries or garages. Do not use it in bathrooms.

WARNING:Your heater shall be used as portable appliance only (thanks to respect all the

safety warnings given below).

Move the heater only by its handles.Never move the heater when it's working. Never let

the heater under the rain or under wet conditions.

Put the heater only on plane, clean & empty surface.

WARNING:Let a minimum distance of 1m between any side of your appliance and any

obstacle (furniture or walls, for example)

4. HOW TO USE

Plug the appliance to a 220-240V~ 50-60Hz socket. If you are not sure, we advice you to

contact a professional electrician for more details.

There is a 4 positions switch on your appliance: 0 (Stop) – Fan only - Fan & heating low

temperature - Fan & heating high temperature.

Turn the thermostat clockwise to increase the temperature.

Set the working time with the timer (0-180 minutes)

When using without timer, the cursor must be on « ON » which indicates the heating

function permanent.

When usint with timer, the cursor must be on « OFF » and hear a "clack" then put the

wanted time from 0 to 180 min.

Table des Matières