Restoring To The Factory Settings; Maintenance; About Bluetooth; Restrictions Of Use - Panasonic RP-BTD10 Manuel D'utilisation

Restoring to the factory settings

When you want to delete all pairing device information, etc., you can restore the
unit to the factory settings (original settings upon purchase).
1 Turn off the unit
2 Press and hold the power
more simultaneously
• The LED on the left speaker will light in red for approximately 2 seconds. The
unit will restore to the factory settings.

Maintenance

Clean this unit with a dry and soft cloth.
• Do not use solvents including benzine, thinner, alcohol, kitchen detergent, a
chemical wiper, etc. This might cause the exterior case to be deformed or the
coating to come off.
6
6
button and Previous for 5 seconds or

About Bluetooth

Panasonic bears no responsibility for data and/or information that is
compromised during a wireless transmission.
■
Frequency band used
This unit uses the 2.4 GHz frequency band.
■
Certification of this unit
• This unit conforms to frequency restrictions and has received certification
based on frequency laws. Thus, a wireless permit is not necessary.
• The actions below are punishable by law in some countries:
– Taking apart/modifying the unit.
– Removing specification indications.
■

Restrictions of use

• Wireless transmission and/or usage with all Bluetooth
not guaranteed.
• All devices must conform to standards set by Bluetooth SIG, Inc.
• Depending on the specifications and settings of a device, it can fail to connect
or some operations can be different.
• This system supports Bluetooth ®
operating environment and/or settings, this security may not be sufficient.
Transmit data wirelessly to this system with caution.
• This system cannot transmit data to a Bluetooth
■
Range of use
Use this unit at a maximum range of 10 m (33 feet).
The range can decrease depending on the environment, obstacles or
interference.
■
Interference from other devices
• This unit may not function properly and troubles such as noise and sound
jumps may arise due to radio wave interference if this unit is located too close
to other Bluetooth ® devices or the devices that use the 2.4 GHz band.
• This unit may not function properly if radio waves from a nearby broadcasting
station, etc. is too strong.
■
Intended usage
• This unit is for normal, general use only.
• Do not use this system near an equipment or in an environment that is
sensitive to radio frequency interference (example: airports, hospitals,
laboratories, etc.).
®
equipped devices is
®
security features. But depending on the
device.
®