Yamaha AV1 Mode D'emploi page 47

RECEIVING RDS STATIONS
Other functions which make use of
RDS data service
This tuner has the following functions which make use
of RDS data service. These are originally in operation
[ON].
However, you can cancel these functions [OFF], if so
desired.
1
2
3
VIDEO 2
PUSH
PHONES
POWER
MINI COMPONENT SYSTEM AV–1
4
<
U.K. and Europe models only
1 2
PRO LOGIC
ENHANCED MO
ROCK CONCERT
DISCO HALL
MEMORY AUTO/MAN'L PRESET/BAND DISPLAY
TIME ADJ TIMER
/ / REPEAT
HOUR MIN
/
RDS MODE RDS START FREQ PS/PTY/RT/CT
OPEN/CLOSE CD
5 3, 6
>
>
ON (OFF) CT
This unit corrects the time of the built-in clock
automatically by synchronizing it with the CT data
on the RDS station being received.
* If you receive an RDS station of some other
country, the built-in clock is synchronized with the
time setting of the country.
* If the built-in clock is not yet set for current time
or reset due to a power failure etc., it will be set
for the time of the CT data automatically, whether
this setting is ON or OFF.
ON (OFF) LOCAL
If the RDS station being received employs the local
time (summer time etc.) data service, its time is
displayed in the CT mode.
* If the setting of function
clock is synchronized with the local time data.
ON (OFF) A. M.
Only RDS stations are searched instead of all FM
stations by the automatic preset tuning operation
when the setting is ON.
(See page 37 for the operating procedure.)
If you switch this function OFF, not only RDS
stations but also other FM stations are
programmed along with MW and LW stations by
the automatic preset tuning operation.
To switch these functions on and off
1
Select the FM band by pressing the PRESET/BAND
button, confirming it on the display.
2
Press the DISPLAY button to display the current time.
3
Press the FREQ PS/PTY/RT/CT selector button.
The title of function
displayed.
4
Select the title of function whose setting you want to
switch by pressing the PTY SEEK MODE button
once or more.
5
Switch the function ON or OFF by pressing the PTY
SEEK START button, confirming it on the display.
6
Press the FREQ PS/PTY/RT/CT selector button
again to restore the frequency display mode.
* If the station has PS data, after that, it turns into
the PS mode.
Notes
● Once the setting is changed, it will be stored until it is
changed again by the above operation.
● During the operation, if there is no operation for
about 20 seconds, this mode is canceled and turns
into the frequency display.
If the station has PS data, after that, it turns into the
PS mode.
E-43
CLOCK
>
CT
is "ON", the built-in
>
RDS
>
"ON CT CLOCK " is