Securing The Child - Diono Cambria 2 Manuel D'instructions

SECURING THE CHILD

WARNING! Use ONLY the lap and shoulder belt
system when restraining the child in this booster seat.
DO NOT use lap belt only.
1. Properly position child into
installed seat. The child should
be sitting upright and seated all
the way back in the booster seat.
2. Adjust head support to proper
height: The shoulder belt guide should be slightly
above the child's shoulders (at least 1 cm). Squeeze
the head support adjustment lever on the back of the
booster seat while adjusting it's height up or down to
fit the child.
2
3. Feed the diagonal portion of the
vehicle seat belt through the
shoulder belt guide.
22
Cambria® 2
4. Fasten vehicle seat belt across child.
5. Tighten the seat belt by pulling
1
6. Confirm seat belt buckle is in
IMPORTANT:
DO NOT
the vehicle shoulder
belt over the
armrest. It MUST
pass through the
lower belt guide.
IMPORTANT:
completely through the shoulder belt guide and not fall
off the child's shoulder.
IMPORTANT:
3 the shoulder and should NOT be touching the child's neck.
SECURING THE CHILD
The lap portion of the seat belt
should rest within both lower belt
guides. Make sure the vehicle seat
belt is not twisted and lays flat
across child's lap, torso and shoulder.
the diagonal shoulder belt portion
in the direction of the arrows.
correct position – it should align
with the RED belt path guides on
head support and side of seat.
position
6
The vehicle shoulder belt MUST route
The vehicle shoulder belt should lay over
diono.com
click
4
5
23