dirna Bergstrom bycool green line COMPACT 3.0 Instructions De Montage page 24

COMPACT 3.0
EN
5 Position the foam rubber, ensuring the softest part
is placed on the base of the unit.
Caution: Depending on the cabin, it may be
necessary to use the (2) supplied ducts in order for
the distribution panel to be completely adjusted.
6
INSIDE CABIN:
Screw about 5 mm (4) 8/125x120 mm studs, the
exact measure is chosen after the fastening sup-
ports have been presented and taking into accou-
nt that studs must stick out of lower part about 20
mm.
7
Following this order:
- Ø 7 plane rubber wash
- plane ruber wash wide wing diameter 8
- nut M8
- plane washer diameter 8 wide wing
6 Unit base
6
plane ruber
Ø 7 plane
wash wide wing
rubber wash
Ø 8
7
24
5 mm
Stud
Bracket
20 mm
Plane washer
Nut M8 Ø8 wide wing
®
5
6