Helite B'safe Manuel D'utilisation page 43

SDU SADDLE SENSOR
Once installed and correctly paired (see page 32), the saddle sensor is totally
autonomous (about 5 years without charging).
SADDLE SENSOR WORKING STATE
However, we recommend to check from time to time (once a month) that the saddle
sensor is working properly.
To do so, you need to place the magnet over the round sign of the saddle sensor to
check that the saddle sensor is still activated and that it is still paired with the vest.
Please note that this check should be done in an environment of more than 10°C.
GOOD TO KNOW
To delete all the sensors that are associated with the vest, press the
button for 8 seconds.
PRECAUTIONS BEFORE USING THE AIRBAG SYSTEM
!
If one of these conditions is not validated, you may not be protected
properly.
the vest is adjusted correctly to your size.
the vest is zipped above the mark Airbag Activation.
the vest is charged (green LED on).
the saddle sensor is paired with the vest.
the green LED is ON and flashes.
User Guide
GREEN LED: battery OK
RED LED: low battery
the sensor.
A Beep on the vest: the saddle sensor and
the vest are associated.
= you need to change
43