Vortice VORT INVISIBLE MINI Notice D'emploi Et D'entretien page 58

ENGLISH
8
3cm
REPLACEMENT OF THE ELECTRONIC BOARD
To replace the elctronic board, it is possible to remove it from the machine by turning the plate tab and pulling
the card towards you. (Figure 9)
9
MAINTENANCE (recommended)
Remove all dust etc. from both the impellor and the motor, taking care not to disturb the balance of the fan.
Refit or replacement is in reverse order.
10
58
To re-insert the condensate collection tray, first raise the
exchange pack by about 3 cm to avoid damaging the seals.
Then insert the fittings into the holes and push the tray and
the exchange pack to the bottom. (Fig.8)
FILTER CLEANING
The machine is equipped with a "Filter cleaning signal",
indicated by an alarm on the display supplied with the
machine. In the presence of this alarm, the machine signals
that the filters are dirty or to be replaced.
Remove the filters, first removing the magnetic covers,
cleaning them or replacing them and putting them back in
the machine. Then reset the filter cleaning alarm through the
special alarm menu in the main menu of the control panel
display. Remove all debris with a soft brush or hoover.