Vortice Reg Depuro Plus Notice D'emploi Et D'entretien page 39

ENGLISH
Low byte: Fan speed with activated PHOTOCATALYSIS-UVC module.
The value that is sent is the rate value (20% to 100%) in 16-bit binary.
Default value: 30 [30%].
Valid for when Record 18 (high byte) = 2 or Record 18 (high byte) = 4.
Record 19: PHOTOCATALYSIS-UVC module schedule [read / write].
High Byte: Start time.
The value that is sent is the time value (0h to 23h) in 16-bit binary.
Default value: 19 [19:00].
Low byte: End time.
The value that is sent is the time value (0h to 23h) in 16-bit binary.
Default value: 6 [6:00].
Record 20: Operating time of PHOTOCATALYSIS-UVC module Hours [reading writing]. Only write allowed
value: 0 (reset).
The value that is sent is the value of the hours (0h to 65000h. The value of 65000h does not overflow) in 16-bit
binary.
Default value: 0 [0h].
Record 21: Operating time of PHOTOCATALYSIS-UVC module Minutes [reading writing]. Only write allowed
value: 0 (reset).
The value that is sent is the value of the minutes (0min to 59min) in 16-bit binary.
Default value: 0 [0min].
Note: The operating time (Records 20 and 21) is only increased if the lamp is activated (Record 59, high byte
≠ 0),
Record 22: Operating hours of PHOTOCATALYSIS-UVC module for dirty filter indication (timer) [read / write].
The value that is sent is the value of hours (disabled function: 0, 1h to 20000h) in 16-bit binary.
Default value: 12000 [function enabled, and UVc lamp alarm indication with operating hours ≥ 12000h].
= 0: Function disabled.
> 0: Function enabled.
Record 23 and 24: Identifier [read / write].
The value that is sent is the value of the identifier in binary 16 bits.
Default value: 0 [0].
The display is 5 digits of 7 segments: 20 bits.
Record 25: Connectivity errors [read / write]. DOES NOT PROCEED IN THIS MODEL
Bit 0: Wifi connection error.
Bit 1: Connection error with the server.
Default value: 0 [0].
This record is not saved in EEPROM.
39