Vasco EnergyPlus ENY–P1 Manuel D'installation, Utilisation Et Entretien page 172

English
COMMISSIONING
Before carrying out the calibration, the fans
are set to the factory speed.
Before the calibration, any speed modifi-
cation performed from the TOUCH PAD is
inhibited and the word "Tab" will flash on
the display, alternating with the time field.
ATTENTION! Without the initial calibration,
it is not possible to change the fan speed.
DAY
1. Turn on the appliance at the ON/OFF key
on the display.
2. Press the ON/OFF and "M" Menu keys at
the same time.
°C
172
3. The symbol
Press Enter to confirm
Use the TOUCH PAD to select the symbol "V"
and confirm .
Use the TOUCH PAD to select fan V1 or V2
and confirm .
Set fan V1 (this is the default intake air
fan):
a) Using the TOUCH PAD, set the required
control voltage according to the detected
operation field on the operating diagra
ms.
V V
Fan voltage
drive signal (VDC)
b) Confirm using the Enter
ATTENTION!: once the confirmation is sent,
the controller waits just a few moments that
the fan speed reaches the necessary value
before the V2 calibration or the exit from the
calibration flow rate menu.
Now set fan V2 following the same procedure
above.
V V
c) C o n f i r m u s i n g
.
ATTENTION!: once the confirmation is
sent, the controller waits just a few moments
that the fan speed reaches the necessary
value before the V2 calibration or the exit
from the calibration flow rate menu.
flashes on the display.
.
+
-
.
-
Fan voltage
drive signal (VDC)
t h e E n t e r
+