Setting The Pressure Switch; Ordering Replacement Parts - HERKULES 40.100.58 Instructions De Service

Anleitung_24-8-1_5_SPK7

Setting the pressure switch

The pressure switch is set at the factory.
Switch-on pressure 5 bar
Switch-off pressure 8 bar
Possible causes of machine failure
Overloading of the motor and hence triggering of the
overload circuit-breaker may result from:
● An excessively high mains voltage
● Excessively high ambient temperatures and an
insufficient air supply
● Defective compressor valves or a leaking non-
return valve
● A low level of oil, sluggish connecting rod
bearings
Leave a.c. motors enough time to cool off before
switching on again. Avoid touching hot components
and pipe lines.

Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
07.09.2006 11:27 Uhr Seite 13
GB
13