Clearances Around Fireplace - Napoleon Acies Série Manuel Du Propriétaire

5.0 clearances around fireplace

Dynamic Heat Control™
EN
WARNING
!
• The Dynamic Heat Control™ system is not available for any appliance from the Acies series (L
models). Do not follow any instructions provided in the "Dynamic Heat Control™ (LV optional / LVX included)"
section if you have an L model. Refer to your appliance installation manual or contact your authorized dealer for
more information. Fire hazard!
• Your appliance, gas/electrical connections, venting and various key components are hidden behind the wall. It
is critical that no screws penetrate the areas illustrated below. Failure to follow instructions may cause improper
operation, damage, personal injury or fire. Always use a stud finder and only screw into studs.
Ceiling
Stud
important:
If in doubt, refer to your installation manual and/or contact your authorized dealer.
16
W415-1713 / A / 08.27.18
Safety Barrier
(L illustrated)
The temperatures above the
fireplace for L models will
be hot, making it unsuitable
for mounting a TV or other
objects sensitive to heat
above the fireplace without
risk of damage.
Installing a mantel
between this appliance and
electronics or other materials
that may be sensitive to
heat will reduce the effect of
direct heat on them.
The size and material of
the mantel will affect the
allowable clearance above
your fireplace and incorrect
placement could become
a fire hazard. Consult your
installation manual and/or
authorized dealer for more
information.
Your fireplace, gas/electrical
connections and vent are
hidden directly behind the
finished wall. Great care
should be taken to avoid
screwing or nailing into these
components. Always use a
stud finder to determine stud
location and only screw into
studs.
Do not screw into the area
around the fireplace opening.
No screws
in this area.
(Screw restriction applies
to ALL models.)