Commissioning; Combustible; Recommended Combustible; Forbidden Combustibles - deville C07335 Mode D'emploi

5.1 - Commissioning

•
After first lighting the fire (see paragraph 5.4.1),
burn a moderate fire for the first few hours, by
limiting the load (one ∅15 cm log) and set the air
intake control lever in the middle position (Fig.
14) : this enables the temperature of all chimney
elements to rise progressively and ensures
normal fireplace dilation.
•
The smell of paint may be detected initially.
Ventilate the room to limit this discomfort.
•
Do not join up the ready to set up to a pipe
already used for other appliances.

5.2 - Combustible

5.2.1 - Recommended combustible

•
Hardwood logs with a maximum length of :
57 cm for C07342
-
63 cm for C07335
-
oak, hornbeam, beech, chestnut, etc.
Maximum loading height :
20 cm for C07342
-
25 cm for C07335
-
•
We recommend that you use very dry wood with
a maximum moisture content of 20%, or wood
that has been stored under shelter for 2 years
after being cut in order to obtain the best yield
and to prevent the accumulation of creosote in
the flue and on the glass.
•
Avoid using resinous wood (pine, fir, spruce...)
which leads to more frequent maintenance of the
fireplace and chimney flue.

5.2.2 - Forbidden combustibles

•
All types of fuel except wood are forbidden,
including coal and its derivatives.
•
Burning kindling wood, branches, planks, straw,
cardboard, liquid fuels is dangerous and is
forbidden.
•
The apparatus should never be used as an
incinerator for waste products.
5.3 -

Operation

accessories
•
Air intake control lever (Fig. 14) : should be
adjusted with the poker.
•
Door handle : This must be operated used the
poker (Fig. 15).
•
Scraper (Fig. 16) : to remove embers and to
clean the appliance.
Do not burn your hands uselessly. Use the
accessories.
5.4 - Operation

5.4.1 - Lighting a fire

•
Set the air intake to normal position (Fig. 14).
of control devices
•
Place some crumpled paper and very dry twigs
on the grate followed by branches of larger
diameter (approximately ∅ 3 to 5 cm).
•
Light the paper and close the door (or leave the
door slightly open to accelerate the blaze).
•
Once the "kindling wood" load is burning, open
the
recommended fuel and use the regulation
devices to obtain the burning required.
5.4.2 – Operation
5.4.2.1 - Periodic and continuous use
•
The intermittent use of the appliance requires a
reload every 45 minutes.
This type of use is particularly recommended as it
environmentally friendly.
•
The apparatus may also be used in continuous
mode when periodic use is not possible or when
reduced burning is required. In this case,
maximum heat output can be maintained for 3
hours and with a slow combustion rate, and a low
heat output, the burning period can extend to 10
hours with a 10 kg load for C07342, 13 kg for
C07335.
The nominal power in intermittent use :
•
Obtained with a 12 Pa draft, with a wood load of :
o
o
as a hard wood and non-split log.
•
Reload every 45 minutes on glowing embers :
o
o
(i.e. 3 cm thickness) with the air intake set to
maximum position.
•
The announced power is the average power
obtained with each 45 minute-load.
The nominal power in continuous use :
•
Obtained with a 12 Pa draft, with a wood load of :
o
o
and
made up of 2 hard wood and non split logs.
•
Reload every 3 hours on glowing embers :
o
o
(i.e. 3 cm thickness) with the air intake set to
maximum position.
•
The burning power given is the average burning
power obtained with each 3 hours load.
Slow combustion, autonomy greater than 10 hours in
continuous use :
•
Obtained with a 6 Pa draft, with a wood load of :
o
o
made up of a hard wood and non-split log
(preferably logs more than 16 cm in diameter).
18
door, load the appliance
3,3 kg for C07335
2,4 kg for C07342
0,5 kg for C07335
0,4 kg for C07342
13 kg for C07335
10 kg for C07342
0,5 kg for C07335
0,35 kg for C07342
13 kg for C07335
10 kg for C07342
with the