Opening The Decomposition Vessel; Preparing The Decomposition Vessel; Closing The Decomposition Vessel - IKA C 7010 Mode D'emploi

Coding no.: Conductor line to separate
III
0
1 X
2
3 X
4
5 X
6
7 X
Table 1 Coding
Example to illustrate table 1, Coding:
No.: 0 No conductor line is separated.
No.: 3 Conductor lines III and II are separated.
No.: 6 Conductor lines II and I are separated.

Opening the decomposition vessel

• Take hold of the decomposition vessel and firmly grip the
bottom part
• Unscrew the cap srew in a counter-clockwise direction to
the bottom part
• Use the venting handle in order to pull out the cover.
The cover may also be removed by pressing on the sides of
the filler neck until the cover is easily pulled out.
The venting handle is part of delivery
quantity for the C7000 calorimeter.
18

Preparing the decomposition vessel

II I
The decomposition vessel is equipped with a fixed ignition wire.
A cotton thread has to be
fastened to the ignition
X
wire in order to carry
X
X out combustion. Fasten cotton
thread as shown in the diagram.
X
X X
X X
Cotton thread

Closing the decomposition vessel

• Put the cover onto the bottom part and press the cover in
the bottom part until stop.
Cotton thread
Inserting the crucible
The crucible can be placed
into the crucible holder
after the combustion sam-
ples have been weigted.
You can find crucibles among the
accessories for the C7010 and C7012