Installation Instructions; Safety Notes; Technical Data - SCHÜTTE Oslo 75800 Instructions De Montage

Dirección de servicio
Franz Joseph Schütte GmbH
Ringstraße 7, 49134 Wallenhorst (ALEMANIA)
 +49 (0) 54 07 / 87 07-0
info@fjschuette.de, www.fjschuette.de
INSTALLATION
GB
INSTRUCTIONS
Dear customer,
You have purchased a high-quality and long-
lasting product from our line of goods. Please
read these instructions carefully before assem-
bling and observe the notes.
These instructions contain important infor-
mation on installation, adjustment, care, and
spare parts.
Therefore, keep the instructions in a safe place
and pass them on to possible subsequent
owners.

Safety notes

• Only allow experts carry out the
installation work.
• CAUTION DAMAGE BY WATER!
Prior to installation please turn the general
water supply off.
• Ensure that all gaskets have the correct fit.
• These taps are not suitable for use on
low pressure and small electrical storage
heaters.
• We recommend the installation of a filter
into the appliance or at least the use of
angle valves with filter, in order to avoid
the inflow of foreign matter, which could
damage the cartridge.
• This tap is only intended for use in private
households! Only suitable for use in rooms
with a temperature over 0° C, when there
is danger of frost.
Shut off the water supply and empty the
tap.
• If the tap not used for a longer period, we
recommend to initially let a larger quantity
of water flow through before withdrawing
drinking water.
• Take care when adjusting the warm water.
Danger of scalding!
Disposal
Your washbasin tap is delivered in a solid
packaging, in order to protect it against
transport damages. The packaging consists
of recyclable materials. Dispose it in an environ-
mentally suitable manner.
Do not throw the product into the normal
domestic waste at the end of its service life,
but ask your municipal administration about
the possibility of an environmentally friendly
disposal.

Technical data

• Flow pressure: recommended 1.5 bar;
install a pressure reducer at more than 6 bar
• Water temperature: max. 80°C
• Water connection: warm - left/cold - right

Installation Instructions

• Only hand-screw the connecting pipes,
do not use pliers or a wrench!
• After installation unscrew the mixer
nozzle, flush the pipeline and the tap very
well (warm/cold water supply), in order to
flush out contaminations (swarf and hemp
remainders). After flushing, screw the mixing
nozzle onto the spout again.
• Do not twist or tension pipes! At first use
check connections for leaktightness!
• We do not assume any warranty for in
correct installation - in particular for subse
quent damages!
The illustrations are to be considered as
figurative representations, deviations of
the product are possible.
Subject to technical modifications.
9