Husqvarna K1 PACE Manuel D'utilisation page 17

For these reasons, a power cutter equipped with a
carbide tipped blade should never be used except
by highly trained public safety professionals who are
aware of the risks associated with its use and then
only in those exigent circumstances when other tools
are deemed inefficient and ineffective for fire or rescue
operations. A power cutter equipped with a carbide
tipped blade should never be used to cut wood in non-
rescue operations.
To examine the spindle shaft and the
flange washers
WARNING:
washers. Minimum diameter for abrasive
blades is 105 mm/4.1 in. and 60 mm/2.36
in. for diamond blades.
WARNING:
with a diamond blade symbol must only
be used with diamond blades. Incorrect
flange washers used on an bonded abrasive
blade increases the risk of blade failure and
injuries.
WARNING:
or dirty flange washers. Use only flange
washers of the same dimension. Incorrect
flange washers can cause the cutting blade
to become damaged or come loose.
Examine the spindle shaft and the flange washers when
you replace the cutting blade.
1. Make sure that the threads on the spindle shaft are
not damaged. Replace damaged parts.
2. Make sure that the areas of contact on the cutting
blade and the flange washers are not damaged.
Replace damaged parts.
3. Make sure that the flange washers are clean and of
the correct dimension.
4. Make sure that the flange washers move freely on
the spindle shaft.
1598 - 002 - 14.02.2022
Use only Husqvarna flange
The small flange washers
Do not use defective, worn
To install the cutting blade
WARNING:
off and that the battery is disconnected.
WARNING:
gloves when you assemble the product.
1. Examine the flange washers and the spindle shaft.
To examine the spindle shaft and the flange
Refer to
washers on page 17 .
2. Put the cutting blade on the arbor bushing (A)
between the inner flange washer (B) and the flange
washer (C). Turn the flange washer until it holds on
to the shaft.
B
3. Put a tool into the hole in the belt guard and turn the
cutting blade until the shaft is locked.
4. Tighten the cutting blade bolt to 30 Nm/18.5 ft-lb.
Make sure that the motor is
Always use protective
A
C
17