Garlando Open Air Guide D'assemblage page 20

Warning: do not install nor screw bearing retainers or handles before you have set all bars.
Check the Diagram of rod assembly provided in the previous page to make sure that the rods position is correct,
before installing the ball bearings.
Slide the rod end with no bearing retainer into the cabinet hole starting from inside the playfield. Insert the opposite
rod end with the bearing retainer without straining it.
Insert the outer blind bearing retainer 2AN201-311
on the cabinet outside, in correspondence to the
inner bearing retainer 2AN201-314. Then and
screw it using a cross screwdriver.
20