Alarm Functions - Jennair W11490758B Guide D'utilisation

INTRODUCTION
1. Turning Refrigerator On and
Viewing Set Points
Your refrigerator and freezer will not cool when
cooling is turned off. Follow the directions
specific to your model.
TURN ON - DISPENSER MODEL
Press and hold Max Freeze and Max Cool
■
buttons at the same time for 3 seconds
Cooling Off button blinks twice and
■
remains on.
TURN ON - NON-DISPENSING MODEL
Press and hold Cooling Off button for 3
■
seconds.
Cooling Off button blinks twice and
■
remains on.
NOTE:
The Cooling ON/OFF touch pad on the
■
control panel shuts down refrigerator
functions such as cooling, lighting, fans
and compressors. To turn the power off
completely, use the power ON/OFF switch
located behind the top grille. See "Power
On/Off Switch."
2. Setting the Temperature F°/C°
DISPENSING MODELS
.Press and hold the Max Cool and Crisper
buttons at the same time for 3 seconds to
change between Celsius and Fahrenheit. When
activated, the selected temperature option
displays. When deactivated, the display is Off.
NON-DISPENSING MODELS
Press F°-C° button to change between Celsius
and Fahrenheit. When activated, the selected
temperature option displays. When deactivated,
the LED is Off.
8 | INTRODUCTION
3. Adjusting Controls
NOTE: Wait at least 24 hours between
adjustments. Recheck the temperatures before
other adjustments are made.
To Adjust Set Point Temperatures:
Press the refrigerator or freezer PLUS (+)
■
or MINUS (-) touch pad until the desired
temperature is reached.
Press the Set To Recommended touch
■
pad to reset the set points to the factory
recommended temperatures.
NOTE: The set point range for the freezer
is -9°F to -3°F (-23°C to -16°C). The set point
range for the refrigerator is 36°F to 43°F
(2°C to 6°C).
CONDITION/REASON: TEMPERATURE
ADJUSTMENT:
REFRIGERATOR too REFRIGERATOR
cold Control 1° higher
REFRIGERATOR too REFRIGERATOR
warm Control 1° lower
FREEZER too cold FREEZER Control 1°
higher
FREEZER too warm/ FREEZER Control 1°
too little ice lower
4. Water Filter Indicator and Reset
See "Water Filter Indicator" section.
5. Max Cool/ Max Freeze
The Max Cool feature assists with periods
of heavy ice usage, full grocery loads, or
temporarily warm room temperatures.
Press MAX COOL to turn on the Max Cool
■
feature. The Max Cool indicator light will
remain on for 24 hours unless manually
turned off.
NOTE: The temperature display will remain at
34°F (1°C) and -5°F (-21°C) for the refrigerator
and freezer compartments, respectively, while
the Max Cool feature is enabled. After 24
hours, the refrigerator returns to the previous
temperature set points.
The Max Freeze feature assists with temporary
periods of heavy ice use by increasing ice
production.
Press Max Freeze to set the freezer to the
■
lowest temperature setting.
Press the Max Freeze feature touch pad
again to return to the normal freezer set
point.
NOTE: The Max Freeze feature will shut off
automatically in approximately 48 hours.
While Max Freeze is ON, changing the
■
freezer temperature will deactivate Max
Freeze.

6. Alarm Functions

Master Alarm Reset
Pressing Alarm Reset once will turn off the
audio alarm and indicator light. The audio
alarm will not sound again for the current
condition that caused the alarm until a new
condition occurs or until a Master Alarm Reset
is performed.