Periodic Maintenance; Cleaning Of The Spark Plug; Troubleshooting - AEG HG654320UM Notice D'utilisation

Masquer les pouces Voir aussi pour HG654320UM:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

shiny metallic discolorations. Use a
special cleaner applicable for sur-
face of hob.
2.
Clean the appliance with a damp
cloth and some detergent.
3.
At the end rub the appliance dry
with a clean cloth.
The stainless steel can become tarnished
if it is too much heated. Refer to this you
must not cook with potstones, earthen-
ware pans or cast iron plates.

6.1 Cleaning of the spark plug

This feature is obtained through a ce-
ramic ignition candle with a metal elec-

7. TROUBLESHOOTING

There is no spark when
lighting the gas
The flame is blow out im-
mediately after ignition
The gas ring burns un-
evenly
If there is a fault, first try to find a solu-
tion to the problem yourself. If you can-
not find a solution to the problem your-
self, speak your dealer or the local Serv-
ice Force Centre.
Problem
trode. Keep these components well
clean to prevent difficult lighting and
check that the burner crown holes are
not obstructed.

6.2 Periodic maintenance

Periodically speak your local Service
Force Centre to check the conditions of
the gas supply pipe and the pressure ad-
juster, if fitted.
Possible cause
• There is no electrical
supply
• Burner cap and crown
are placed uneven
• Thermocouple is not
heated sufficient
• Burner crown is
blocked with food resi-
dues
ENGLISH
Remedy
• Make sure that the
unit is connected and
the electrical supply is
switched on.
• Control the fuse. If the
fuse is released more
than one time, refer to
a qualified electrician.
• Make sure that the
burner cap and crown
are in correct posi-
tions.
• After lightning the
flame, keep the knob
pushed for approxi-
mately 5 seconds.
• Make sure that the in-
jector is not blocked
and the burner crown
is clear of food parti-
cles.
If you operated the appliance in-
correctly, or the installation was
not carried out by a registered
engineer, the visit from the cus-
tomer service technician or deal-
er may not take place free of
charge, even during the warranty
period.
23

Publicité

Table des Matières
loading

Table des Matières