Adjusting The Length Of The Telescoping Tube; Accessories - Cleanmaxx PC-C001-6 Mode D'emploi

EN

Adjusting the length of the telescoping tube

Accessories

PLEASE NOTE!
■ Always turn off the device and pull the mains plug out of the socket before you
change the nozzles!
The different nozzles can be mounted either on the tapered end of the telesco-
ping tube or directly on the handle.
Floor nozzle
Tile nozzle
18
2. Insert the tapered end of the telescoping tube in the desi-
red nozzle (see also section "Accessories"). For better
seating, gently turn the tube back and forth in the process.
3. If not in use, you can attach the tile and brush nozzle to
the bracket provided on the handle as shown.
1. Push the slider up and hold it down.
2. Set the desired length of the telescoping tube and release
the slider.
3. Push the telescoping tube further until it audibly locks into
place.
The fl oor nozzle is suitable both for carpets and smooth
fl oors. You can switch between a smooth fl oor and carpet
using the foot switch:
• A brush and rubber lip can be folded out on the bottom
of the nozzle for smooth fl oors.
• The brush and rubber lip are folded in when cleaning
carpet fl oors.
The tile nozzle is suitable for padding, cleaning the inside
of passenger vehicles as well as every nook and cranny
that can't be reached with other nozzles.