Inserting The Batteries - switel BCC 47 Mode D'emploi

6 Starting Up

1. Inserting the batteries

S
Slide the belt clip downwards until it audibly snaps into place.
Pivot the belt clip an angle of 45° back from the battery
compartment.
S
Open the battery compartment as illustrated in Fig. II.
S
Insert 3 AAA batteries each in the transmitter unit and in the
receiver unit, paying attention to the correct polarity.
S
Close the battery compartment.
2. Operating using the power adapter plug
S
Connect the power adapter plug to the DC 6 V socket on the
transmitter unit and to the mains power socket.
S
Connect the charging station to the mains power socket and
insert the receiver unit in the charging station.
S
Set the channel selector on the transmitter and receiver units to
the same channel (CH1 or CH2).
40
Only use batteries bearing the CE certificate.
Please charge the batteries fully (9 hours) before using the
equipment for the first time. During the charging process,
they must not be removed from the transmitter/receiver
unit when they are operated using the power adapter plugs.
The battery icon flashes during the charging process and
stop flashing when the charging process is completed.
Only use adapters which bear a CE certificate.