Safety Information; Intended Use; Installation Location; Power Supply - switel BCC 47 Mode D'emploi

Table des Matières

Les langues disponibles

4 Safety Information

Please read this operating manual thoroughly. Under no circum-

stances open the devices yourself and never carry out any repair

work yourself. In the case of claims under the terms of guarantee,

please contact your sales outlet. SWITEL reserves the right to make

modifications to the technical specifications and design within the

scope of product improvement.

This Babyphone has been developed purely for monitoring voice sig-

nals, e.g. from children.

The charging unit for the receiver must be installed in the vicinity of a

230 V power socket. Set the Babyphone units down on a flat, non−slip

surface. Normally, these devices do not leave marks on the surfaces

where they are located. However, due to the number of paints and

surfaces which come into question, it cannot be fully ruled out that the

housing will leave marks on the surfaces where they are located. By

sliding the belt clip down until it audibly snaps into place and then pi-

voting it 45° to the rear, it serves as a positioning aid.

Only use the SWITEL power adapter plug contained in the material

supplied since other power adapter plugs could damage the Baby-

phone. Never open the power adapter plug. If the power adapter plug

is opened when connected to the power supply socket, there is a risk

of fatal injury.

Never use the power adapter plug with non−rechargeable batteries.

This would bring the risk of explosion!

Table des Matières