Anti-Freeze Function; Problem Solution - BiAL ILS Mode D'emploi

currently set. Settings can be modified as
required while the device is working (but-
tons and ).
If the device was off before the timer mode
was activated, it will turn off automatically
on termination of t he timer.
If the device was set to i.e. setting 2 before
the timer mode was activated, and is then
modified to i.e. setting 4, the device will re-
turn to setting 2 after 2 hours.
Attention: if the device is on and settings are
not modified on activation of TIMER, settings
will not change after 2 hours. It will still op-
erate on the same setting.
TROUBLESHOOTING
Problem
Device is connected to
electricity, no diodes are
on
Device heats despite hav-
ing been turned off with
{on/off} button
If the problem persists, please contact your local distributor.
14
Press button at any time to stop the TIMER
mode. Turning the device off and back on
with the
function.

ANTI-FREEZE FUNCTION

(Anti-freeze protection)
When the device is off and the temperature
around temperature sensor drops to below
6° C , the device will switch on automatically.
This is to prevent the heating medium inside
the radiator from freezing. Activating Anti-
freeze mode is indicated by flashing of the
centre diode.
Possible cause
Connection problem
Electronics problem
button will also deactivate the

Problem solution

Check the mains connec-
tion, check if the power
supply is correct
Disconnect the device
completely from electricity
and wait until the radiator
cools down. Turn the de-
vice back on