Turning On The Dr 460 C; First Time Configuration - Albrecht Audio DR 460 C Guide D'instructions

10 Turning on the DR 460 C

To turn on the DR 460 C
1. Plug the supplied power adapter in a power outlet.
2. Connect the power adapter to the DC power jack on the rear panel
3. Connect RCA cables to your existing Hi-Fi stereo.

First time configuration

10.1
The first time the DR 460 C is powered on you have to choose the language first:
Use the up/down navigation buttons on your remote control to choose your
preferred language and press OK.
Then choose whether or not the DR 460 C should enable "Check network when power
on" Use the left/right navigation buttons to choose and press OK. If you enable this
option the radio will check if there are networks which the radio already knows. If that is
not the case the radio will display a list of all networks available.
Choose how you wish to configure your network.
If Yes was chosen first, find your
for the first time:
network on the list shown on the screen and press ok.
English 43