Whirlpool W10325308A Instructions D'installation page 8

2.
Check levelness of washer/dryer
place level here
Place a level on top edges of
washer/dryer, checking each side
and front. Rock machine back and forth to make sure all four
feet make solid contact with floor.
Not Level
If not level, adjust pedestal feet up or down, repeating as
necessary.
3.
Adjust pedestal feet
Locate the 1/4" hex-head screws on the top of each pedestal
foot. Reach inside the pedestal and use a 1/4" hex-head ratchet
or open-end wrench to adjust the feet up or down as needed,
to level the washer/dryer.
NOTE: Make sure all four pedestal feet are in solid contact with
the floor.
8
LEvEL Not Level
4.
Securely tighten locknuts
When the washer/dryer is level and all 4 pedestal feet are in firm
contact with the floor, use a 9/16" open-end wrench to securely
tighten all four locknuts against the pedestal.
IMPORTANT: The locknuts must be tightened to avoid
vibration.
Reinstall pedestal drawer
1.
Reassemble pedestal drawer
Drawer slide
Hex-head screw
Pull both drawer slides out and reassemble the drawer to the
drawer slides with the two hex-head screws.
2.
Place drawer divider in drawer
Remove the shipping film from the drawer.
Place the divider in the drawer at the desired
location. Close the drawer.
NOTE: Use of the divider is optional.