Installation Requirements; Location Requirements; Tools And Parts; Unpacking The Pedestal - Whirlpool W10325308A Instructions D'installation

INSTALLATION REQUIREMENTS

LOCATION REqUIREMENTS

NOTE: If the washer/dryer and pedestal assembly are located in
a garage, 3" (76 mm) must be added under the pedestal so that
the washer/dryer is 18" (460 mm) above the garage floor.

TOOLS AND PARTS

Gather the required tools and parts before starting installation.
Tools Needed:
Utility knife
Level
Pliers or slip-joint pliers
1/4" nut driver
2
1/4" hex-head ratchet
or open-end wrench
9/16" open-end wrench
Bucket
5/16" hex-head ratchet
or nut driver
Additional Items Needed:
Towel
Parts Supplied:
Four #12 x 5/8" hex-head
sheet metal screws

UNPACKING THE PEDESTAL

Preparing the pedestal for installation
IMPORTANT: Set the pedestal box aside for use during
installation.
1.
Empty pedestal drawer
Open the pedestal drawer as far as possible and remove the
contents. The package contains four, #12 x 5/8" hex-head sheet
metal screws and a drawer divider.
Sponge
Drawer divider